Kysor K26 Rear Air Fan Clutch Kit Masters # 8801N Ref.# 1090-09500-01 2602141C91

Description

New Genuine Kit Masters K-26 Rear Air Fan Clutch P/N 8801N(includes hardware and instructions as pictured).
NO CORE CHARGE OR CORE
EXCHANGE IS NEEDED WITH THIS ITEM.  THIS ITEM IS SOLD OUTRIGHT.
Alternative and other replacement reference part numbers:
Cummins 3415013, Navistar/International 2509380C91, Industry # 1090-09500-01.
Other OEM reference part numbers:
1090-08500-01, 1090-09600-01, 1090-09600-01B,
2501022c91,
2602141c91,
3915592,
6514-070-1, 65140701,
85108716,
85111808, 85114233,
9908500,
9908501,
f8hz-8a627-ua.
Description:
Kysor Style.  K-26 Rear Air Fan Clutch.  Most common 2003 - present.
Please Contact us if you have any doubt about what parts you need, or please contact your local OEM dealership for correct part number to ensure correct part.
Check out my
other items
!  We can also combine orders to save on shipping.
If you need any parts not found on our eBay store let us know, we may have the part in store and we don't mind making an eBay page for it.
We're an authorized dealer of Excel and PAI products, please let us know if there is any other parts you might need, thanks.
8801N Instructions
REMOVAL OF OLD CLUTCH
Remove clutch to be replaced.  There are 6 bolts that secure the clutch to the hub (pulley).  These are Allen head bolts.  Use a 5/16” Allen wrench to remove.  There are 6 access holes in the front of the clutch that allow you to access and remove the Allen bolts.  If the access holes are not aligned with the Allen bolts, you can apply air to the clutch to disengage it.  Then rotate the hosing until the access holes line up with the Allen bolts for removal.
Once the clutch is removed from the hub (pulley), inspect the pulley to be sure there isn’t “play”.  Any “play” indicates worn bearings in the pulley.  If you find “play”, rebuild the pulley with the proper bearing kit.  (If you do not repair the hub, the new clutch will prematurely fail).
REPLACEMENT
The airshaft (in the center of the pulley) should be wiped clean.
Remove the plastic coupling from the new 8801N fan clutch and place it on the airshaft of the hub. (see picture below)
Be sure the exposed o-ring, (located on the backside of your new 8801N) that will be placed in the hub’s airshaft, is lubricated and intact (it comes pre-lubed).  Line up the slot on the shaft (on the new 8801N ) so it will slip into the plastic coupling you have placed on the hub’s airshaft
(The most common cause of premature failure is, during installation the exposed shaft o-ring is cut or nicked while placing the clutch onto the hub.)
You will need to line up the mounting holes on the replacement 8801N with the holes on the pulley.
Torque the 6 Allen head bolts to 45 lbs.-ft. (clutch to pulley)
Torque the fan to the clutch to 26 lbs.-ft.